Free ground shipping on orders over $35
  • Visit Our Other Stores:
  • Home
  • Abominable Snow Beast Yeti Waving WiperTag
Abominable Snow Beast Yeti Waving WiperTag
Abominable Snow Beast Yeti Waving WiperTag

Abominable Snow Beast Yeti Waving WiperTag

$21.99
  • SKU: 810111384193
Description

An Abominable Snow Beast sighting everywhere that you go!

The waving Abominable Snow Beast installs on most rear wipers and can be positioned left or right-sided. It can also be mounted onto top-mounted wipers, where the wipers are upside down. They are made from laminated UV-protected decals. Instructions are included in the package.

  • Fits most rear wipers, left or right side
  • Laminated UV Protected decal
  • Sasquatch Decal: 9.71" x 9.75"
  • Sasquatch Arm WiperTag: 8.25" x 2.75"

Installation Instructions:

  1. Clean and dry the rear window and wiper thoroughly
  2. Attach the waving paw to the wiper according to the instructions on the packaging. You will be able to adjust slightly left or right as necessary.
  3. Before removing the back of the decal, align it to the best side of the wiper for positioning. The paw will work fine on either side. If needed, you can trim the decal to fit around the wiper arm if yours is mounted through the window.
  4. Remove the decal backing, align the level with minimal touching on the adhesive, and from the bottom up gently lay the decal on the window pushing out any wrinkles on the way up. Remove and realign if needed, but be careful not to tear.
  5. Follow up by using a credit card or something thin and flexible to push any wrinkles or bubbles toward the outside of the decal.
  6. To get the most from your decal, keep your wiper blades free of dirt and debris. Remove the WiperTag arm before entering a car wash.
  7. To remove the decal, make sure it is not freezing or it could tear. Remove indoors, warm with a blow dryer, or heat the inside of your vehicle. Make sure your hands, window, and decal are clean and dry. Simply pick off an edge and slowly peel it off, then apply back to the original paper. Remove WiperTag arm by tilting sideways and unlocking. The number of times the decal can be reused varies depending on well it is taken care of.

*If your wiper is mounted on top, your character will be upside down, which is actually still really cute. Wipers mounted below the window may not create the same desired effect. Please check with your local and state laws regarding window decals and exterior accessories prior to ordering.

Reviews

You might also like these.

BACK TO TOP